3 - 1   

• The driver s seat can be adjusted forward and backward according to the operator sizes, it also can adjusting base on the operator weight.

3 - 2   

• The two forks can be set to any desired position by changing stopper position, after adjusting the forks, make sure that the stoppers have been properly inserted.In order to have a good balances between lift cylinder and fork, on both side should be the same.

3 - 3   

• Stop the engine on horizontal ground for 5 minutes, then pull out the level gauge and wipe it with clean cloth. Insert the gauge again to its former position and then draw it Out, check the: position of the oil adherence to see whether the oil level is within the normal range. 

Notes:

1. Replace the engine oil at the end of first week (50 hours) and at the end of first month (200 hours). After that, replace every month.
2. Use the same brand of engine oil whenever possible.

3 - 4   

• Both sides of this forklift truck are tanks.
• The right side is hydraulic oil tank, and the left side is fuel tank. To inspect whether the oil level is in the normal dangle, lower the fork to its lowest position first.
• Pull out the level gauge and wipe it with clean cloth, insert the level gauge once again into the tank and then draw it out carefully and check the position of the oil abberence.
• If below the .'Low" level, add the oil up tp the "Full" level, but do not over.