1. Grasp the round knob on steering wheel, control the steer wheel with left hand only.
2. Controt lift, Litt and velocity levers with right hand.
3. The lifting speed of forks and forward, backward tilting speeds of mast are controlled by levers of hydraulic control valve and accelerator pedal of engine.
4. The lowering speed of forks is controlled by lift lever only instead of accelerator pedal.

1. Lift the forks about 150mm above the ground.
2. Keep the mast vertical or bile backward slightly.
3. Starting from low speed.

1. Adjust the expanding distance of two forks according to the load center to suit pallet width.
2. Before inserting, tilL the mast forward slightly.
3. 0n approaching the load to be carried, set the fork underside parallel with the ground and carefully advance into, the toad.
4. Insert the forks up to their bases slowly.

1. Lift the forks slowly to touch the pallet.
2. Tilt the mast backward lightly, lift the loads up about 150mm above the ground then proceed to the unloading point.

Taiwan Combitech Co., Ltd.

160 Huei-Chung Road Taichung 407 Taiwan 

Tel: +886 2311-2413

 Fax: +886 2311-2415    

Contact: info@Combitech.com.tw  

http://www.combitech.com.tw       

¡@

Vietnam Representative Office

356/6/12 Bach Dang Street, Ward 14 

Binh Thanh District, Ho Chi Minh City, Vietnam

Tel: (84-8)551 2576

 Fax: (84-8)294 2848  

 Email: combitech@hcm.fpt.com.vn    

http://www.combitech.com.vn