1. Tilt the mast fully backward, keep the load as low as possible while moving.
2. Watch your side clearance, especially with wide loads. When possible, drive in the center of the road.
3. When the load blocks the forward view, backing is recommended.

1. Proceed the truck straightly to the unloading point.
2. Pause the truck about EM before the unloading point.
3. Lift the lead about ~ 50mm above the unloading point.
4. Hold the brake, set the velocity change lever in neutral and release the clutch pedal before lifting the toads.
5. Move the truck forward again and pause about 120-200mm before the unloading point.
6. Set the mast vertically, and lower the forks and set the toad at the objective place.
7. Without changing the most tilt, back up the vehicle to draw the forks from the load, then set the forks 150-200mm above the ground again and start off the vehicle.

1. When loading, give attention to the fork height so that the fork tips wit! not strike the load. ,
2. Do not plunge suddenly into the load.
3. When running with the toad, the forks should be 150-200mm above the ground anci the mast titts fully backward.
4. Avoid running with the forks lifted high and the mast tilted forward.
5. When descending a slope under load, reverse the truck and.descend slowly.

Taiwan Combitech Co., Ltd.

160 Huei-Chung Road Taichung 407 Taiwan 

Tel: +886 2311-2413

 Fax: +886 2311-2415    

Contact: info@Combitech.com.tw  

http://www.combitech.com.tw       

¡@

Vietnam Representative Office

356/6/12 Bach Dang Street, Ward 14 

Binh Thanh District, Ho Chi Minh City, Vietnam

Tel: (84-8)551 2576

 Fax: (84-8)294 2848  

 Email: combitech@hcm.fpt.com.vn    

http://www.combitech.com.vn